How to prevent and fix faucet leakage?

October 31, 2018

Tap in the kitchen or the living sentor is very common,so do you have the problem that your faucet ofthen tighten to leakage,the situation will directly replace the faucet,however,do you know the reasons for the leakage for the faucet.If that is happen,we advice you the below actions

1.Remove the valve cores,if you close the valve,the faucet is still out of water, the pressure cap may loosen or deformation of the apron at the bottom of the valve plug maybe caused.For theformer,it is recommended that the handle and the decorative cover can be removed and thepressure cap can be tightened again.If the latter is the case,it is recommended to remove the valve core,check the rubber ring and reinstall it.

2.If the tap leaking-water seepage from around the valve core,may be the valve core loose or off set,it is recommended to remove the valve core to re-install once.

3.If the water leakage -water seepage from the middle of the valve core,it indicates that the spool is damaged.At this time,it is recommended to replace the spool only.

4.Lead bottom leakage,if this phenomenon may be caused by the inlet pipe O-ring is not installed or deformed,it is recommended to unscrew the hose to see if the O-ring is loose,if you loosen and reinstall it.if it is found that the O-ring has been deformed,it is recommended to replace the O-ring.

How to prevent faucet leaking :

1, choose ceramic and copper body spool

When buying a faucet, it is necessary to look at the material of the faucet. The valve core of the high-grade faucet is made of hard ceramic and copper. The feel is comfortable, smooth, and the number of opening and closing can be several times. The low-grade faucet built-in valve core uses a steel ball valve. The rubber ring in the steel ball valve core is easy to wear out and deteriorate, and the water leakage phenomenon easily occurs over time.

2, control the intensity of the switch tap

When using the faucet, it is necessary to control the strength of the switch faucet, because the valve plug has been adjusted to open and close the angle. Excessive effort is often used to open the tap valve core, which will cause damage to the spool and lead to dripping or water leakage. In addition, as far as possible, the sand in the inlet pipe should be drained before installing and installing the faucet, and then the inlet pipe of the faucet should be connected to prevent the leakage of sand and other foreign matter from flowing into the faucet spool.

handy faucets is made by brass valve core ,and ceramic valve core .Five years no leakage,if youwant to know handy product,please pay attention to the information of the websit.

vorig

Neem contact op

Author:

Ms. linly

Phone/WhatsApp:

+86 13751081118

populaire producten

Nieuws

Voor wat voor bekkens zijn bassinmixer kranen geschikt?

November 24, 2023

Hoe kies je een waterbesparende kranen?

November 09, 2023